How to make Bangpae2012.03.10 00:09

| Post views: How To Recover Deleted File

Bangpae bridle is 3 point one not that of 4, the fake one at center upside is just to prevent spine bent against strong wind pressure.

Step 1.

Prepare thread to be duplicated that length is about 1.5 times of head width or kite diagonal.

Step 2.

Make a double thread knot with thread length of from kite center to bottom corner end.

Step 3.

Tie at start point between kite upper and center with double thread prepared on step 2.

Step 4.

Drag thread from the point of step 3 via right side bottom corner end to left upper corner end.

Step 5.

Overlap main thread with that of prepared on step 1 at the step 4 end point, turn kite over with keeping the threads don’t move, wind threads 3 turns clockwise to the spar end, pull main thread toward me, and then make a clockwise ring against left index finger, next insert the made ring into stick out corner spar, finally pull out to tie main threads with right fingers while left 3 fingers-middle,ring,the little-fixing corner threads.

Step 6.

Drag thread from the point of step 5 via upper center down 22~25 (mm) to left upper corner end while thread tension taut, then turn kite over again with keeping the threads don’t move, wind threads 2 turns clockwise to stick out corner spar, pull main thread toward me, and then make a closckwise ring against left index finger, next insert made ring into stick out corner spar, finally pull out to tie main threads with right fingers while left 3 fingers-middle,ring,the little-fixing corner threads.

Step 7.

Wind thread 1 turn to the stick out corner spar of the step 6,spread out string to make bow string stable.

Step 8.

Drag thread from the point of step 7 via bottom left corner end to bottom right corner end, then make a double thread knot at here with thread length of from this point to the opposite kite center hole end.

Step 9.

Tie a knot at bottom bridal point  with double thread prepared on step 8.

Step 10.

Make a 4 thread overlap knot and this knot point should coincident to the end point of step 9 and 10 mm down from the upper corner ends when pull out thread up and down, and the thread from the start point of step 3 must be a little bit droop status.

Step 11.

Tie a swivel.

저작자 표시 비영리 변경 금지
신고
Posted by 대한연협회 Peter, Nam

티스토리 툴바